Commercial garage door opener repair
When the operator fails, a perfectly good door becomes a door you have to chain open or leave shut. Tell us what it's doing and we'll connect you with a local company that repairs commercial door operators.
Typical prices: service call $150–$400 · most door repairs $200–$1,500 · dock leveler repair $500–$3,000 · new dock leveler $5,000–$15,000 installed. See the cost guide.
Request service- Free referral service: independent local companies pay us a marketing fee, not you
- Independent local companies that work on commercial doors and docks
- You get the quote directly from the company doing the work
Common operator problems
- Nothing happens. Power, a tripped breaker or overload, a stop button latched in, or a failed control board.
- Motor hums but the door doesn't move. A failed capacitor, a broken drive chain or coupling, or the operator left in manual mode.
- Door starts down, then reverses. Photo eyes blocked or out of line, a damaged reversing edge, or force settings out of adjustment.
- Door stops short or runs past its stops. Limit settings have slipped or the limit switches are worn.
- Grinding or chattering. Worn gears, a dry or stretched chain, or a brake problem on hoist-type operators.
- Remote or wall control doesn't work. Wiring, a failed receiver, or a damaged control station.
Types of commercial operator
Trolley operators mount on the ceiling and pull the door along a rail, like a large home opener. Jackshaft operators mount on the wall beside the door and turn the door's shaft. Hoist operators add a chain hoist so the door can be raised by hand if the power fails. Many commercial operators run on three-phase power, so tell the repair company the voltage if you know it.
Check the door before blaming the operator
An operator only moves a balanced door. If the door is hard to lift by hand when released to manual, the problem is usually a broken spring or cable, not the operator. Running an operator against an unbalanced door burns it out. Our door won't open or close guide covers the safe checks.
Repair or replace the operator?
Boards, capacitors, limit switches, chains and photo eyes are routine repairs. Replacement makes sense when the motor or gearbox has failed on an older unit, parts are no longer available, or you need a faster or heavier-duty operator for a busy door.
Commercial door opener repair: common questions
Can the door be opened when the operator is broken?
Usually yes. Most commercial operators have a manual release or a chain hoist. Only use it if the door is balanced and in its tracks; a door with a broken spring can drop.
Why does the door reverse just before it closes?
Most often the photo eyes near the floor are dirty, knocked out of line or blocked. If they're clear, the reversing edge or the force setting may need attention.
Is it worth repairing an old operator?
If the motor and gearbox are sound, replacing a board, capacitor or limit switch is usually far cheaper than a new operator. If the motor has failed on an old unit, replacement is often better value.
Can you match our existing operator brand?
Many repair companies service the major commercial brands. Tell them the make and model from the label on the operator so they bring the right parts.
Do you repair operators yourselves?
No. Commercial Door Repair Now connects you with an independent local repair company, which gives you the quote and does the work.
Need a door or dock fixed?
Use the form at the top of this page.