Commercial garage door won't open or close
A door stuck open leaves the building unsecured; a door stuck shut stops trucks. Here are the common causes, the quick checks that are safe to do, and when to call a technician.
Typical prices: service call $150–$400 · most door repairs $200–$1,500 · dock leveler repair $500–$3,000 · new dock leveler $5,000–$15,000 installed. See the cost guide.
Request service- Free referral service: independent local companies pay us a marketing fee, not you
- Independent local companies that work on commercial doors and docks
- You get the quote directly from the company doing the work
Safe checks first
- Power. Check the breaker and any disconnect switch for the door operator.
- Stop button. Make sure the stop button on the wall control isn't latched in.
- Safety sensors. The photo eyes near the floor must face each other with nothing in between. A dirty or knocked lens is a very common reason a door won't close.
- Obstructions. Look for anything in the tracks or under the door.
- Manual release. If the operator has a disengage cord or a chain hoist, the door may have been left in manual mode.
Do not touch the springs, cables or the bottom brackets. They are under high tension and cause serious injuries.
Door won't close or reverses
- Misaligned or blocked photo eyes.
- A damaged or wet reversing edge on the bottom of the door.
- Bent track or a damaged section binding as the door comes down.
- Operator limits or force settings out of adjustment.
Door won't open
- Broken spring. The most common cause. The door feels extremely heavy and the operator strains or stops. You may see a gap in the spring coil.
- Broken or slipped cable. The door may hang crooked.
- Operator failure. The motor hums or does nothing, but the door moves when released to manual.
- Frozen bottom seal in cold weather, stuck to the floor.
Door is crooked or off its track
Stop using it. A door that is crooked or has a roller out of the track can fall. This usually follows a forklift or trailer impact, or a broken cable on one side.
Rolling steel doors
Roll-up doors fail in similar ways: a broken barrel spring, bent slats, worn guides, or an operator fault. Bent bottom slats from impact are the most common repair.
When to call a repair company
Call a technician for anything involving springs, cables, bent track or sections, a door off its track, or an operator that still won't work after the safe checks. Tell them the door type, its size, what it is doing, and whether it is stuck open or shut, so they bring the right parts. For rough prices, see the repair cost guide.
Need a door or dock fixed?
Use the form at the top of this page.